Replacing V-Belts; Adjusting Tension Lever - Grizzly G0636X Owner's Manual

Replacing V-Belts

Tools Needed:
Hex Wrench 6mm .............................................. 1
Wrench 13mm ................................................... 1
To replace the V-belts:
1. DISCONNECT BANDSAW FROM POWER!
2.
Open the wheel covers and remove the
bandsaw blade (see Page 36).
3. Loosen the motor adjustment bolts and ten-
sion nut shown in Figure 62, then turn the
tension bolt counterclockwise.
4.
Unthread the wheel cap screw shown in
Figure 63 and slide the lower wheel off of the
bearing shaft.
Figure 63. Wheel cap screw for removing the
wheel.
5. Slip the old V-belts off of the pulleys and
install the new V-belt set in their place.
6.
Install the lower wheel back onto the bearing
shaft, tighten the wheel mount cap screw,
and tension the V-belt (see Page 44).
7. Close the lower wheel cover.
G0636X 17" Ultimate Bandsaw
Qty
Wheel Cap
Screw
-45-