Grizzly G0636X Owner's Manual page 50

9. Figure 69 shows the positions of the wheels
when coplanar. When your wheels are copla-
nar, reinstall the table, table insert, and pin,
readjust the guide blocks and rear support
bearings, and close the wheel covers.
10. Finally, check table and fence alignment (see
Pages 25 & 26).
Coplanar
Coplanarity
Gauge
Contacts Top
And Bottom of
Both Wheels
-48-
Note: The blade may track slightly off-center
when the wheels are coplanar. This is natural
because the blade will be balanced on the crown
of the tire, rather than just in the center of the tire.
This will be more noticeable with larger blades.
Parallel, Not
Coplanar
Shim Upper
Wheel Out
Figure 69. Coplanarity diagram.
Not Parallel
Not Coplanar Tracking Knob
Adjust
Lower
Hub
G0636X 17" Ultimate Bandsaw
Adjust