Top View
Bandsaw
Figure 27. Illustration of blade set perpendicular
(90˚) to the support bearing face.
5.
Tighten the guide block assembly cap
screws.
6.
Loosen the bolt on the support bearing
adjustment shaft—if it is not already loose.
7.
Using a feeler gauge between the support
bearing and the blade, position the bearing
0.016" away from the back of the blade, as
illustrated in Figure 28.
Side View
Figure 28. Blade aligned 0.016" away from the
bearing edge.
-24-
Blade
Support
Bearing
G0636X 17" Ultimate Bandsaw