Replacing Main Motor Belts - Grizzly G0764 Owner's Manual

Replacing Main Motor Belts

Two belts transfer power from the main motor to
the main blade. These are standard off-the-shelf
belts and can be purchased from Grizzly using
part #P07640423.
The main motor is extremely
heavy. DO NOT attempt
to lift it up with only your
hands. To avoid crushing
injuries, always use the
following procedure when
replacing the main motor
belts.
Items Needed
Wrench 17mm.................................................... 1
To replace main motor belts:
1. DISCONNECT MACHINE FROM POWER!
2. Open cabinet door, then loosen lock handle
shown in Figure 151.
Lock
Handle
Figure 151. Main motor V-belt tension controls
(table removed for photo clarity).
-76-
Qty
Adjustment
Lever
3. Move adjustment lever shown in Figure 151
up and to the left to release belt tension.
4. Carefully position belts onto desired pulleys
(see Change Speed on Page 48 for addi-
tional information).
5.
Move adjustment lever down and to the right
to fully tension the belts.
6. Retighten lock handle loosened in Step 2 to
secure tension setting.
7.
Close cabinet door before reconnecting
machine to power.
Model G0764 (Mfd. Since 02/14)