Grizzly G0636X Owner's Manual page 43

To lubricate the table tilt rack and pinion
assembly:
1.
DISCONNECT BANDSAW FROM POWER!
2.
With the table perpendicular to the blade,
wipe off all existing grease and sawdust
buildup from the rack.
3. Move the table up to its maximum 45˚ angle
and wipe (Figure 59) off all existing grease
and sawdust buildup from the rack.
Figure 59. Table tilt rack and pinion assembly.
4.
Apply a thin coat of light all-purpose grease to
the rack.
5.
Move the table up and down several times
to distribute the grease, then wipe off any
excess grease.
G0636X 17" Ultimate Bandsaw
To lubricate the trunnions:
1. DISCONNECT BANDSAW FROM POWER!
2. Move the table up until it reaches its maximum
45˚ angle and wipe off all excess grease and
sawdust from the trunnions.
3.
Apply a thin coat of light all purpose grease to
the trunnions (Figure 60).
Figure 60. Trunnion lubrication location.
4.
Move the table down and then back up to dis-
tribute the grease, then wipe off any excess
grease from the trunnions.
-41-