Edit While Viewing The Slider/Knob Values (Edit Scope) - Roland JP-8080 Owner's Manual

Edit While Viewing the Slider/Knob
Values (Edit Scope)
If you wish to edit while viewing the value of the
slider/knob, you can use the following procedure to make
the parameter value appear in the display.
* The values of the following knobs cannot be viewed in
the display.
• VOLUME [LEVEL]
• EXTERNAL INPUT [INST/LOWER] and [VOCAL/UPPER]
1
Press [EDIT].
The [EDIT] indicator will light and the BANK [1]–[8]
indicators will blink.
2
Press [SCOPE] (BANK [8]) several times to access
the Edit Scope display.
The [SCOPE] indicator will light.
3
While viewing the value, move the slider/knob that
you wish to edit.
The value of the slider/knob you moved will appear in
the display.
By pressing [DEC]/[INC] you can modify the value in
steps of 1.
* If at this point you press [SCOPE], the (Edit) indication
in the lower left of the display will disappear, and the
Temporary Scope (refer to previous section) will appear.
4
To end Edit Scope, press [EDIT] or [EXIT].
* Sometimes, moving a slider/knob will not make the dis-
played value change in increments of 1. In such cases,
use [DEC]/[INC] to set the value.
* When you are in the Performance/Patch select pages,
you can hold down [SHIFT] and move a slider/knob to
view the value as you edit. Also, you can use
[DEC]/[INC] to modify the value in steps of one.
* If you use the Edit Scope when the Voice Modulator
panel (p.111) is selected, an "x" will sometimes appear
in the display. This indicates that when the vocal effects
algorithm (p.108) is set to "FLT BANK WIDE" or "FLT
BANK NARROW," this parameter is invalid.
64
Velocity Edit Scope and Control Edit
Scope
The width of change for the various parameters assigned to
Velocity (p.82) or Control (p.84) can be edited while you
view the value in the display.
1
When the Edit Scope page is displayed, press
[VELOCITY ASSIGN] or [CONTROL ASSIGN].
The indicator will blink, and the display will indicate
either "Vel. Edit Scope" or "Ctrl Edit Scope."
2
Move the slider/knob whose value you wish to set.
The parameter and width of change for the slider/knob
you moved will be displayed.
You can use [DEC]/[INC] to modify the value in steps
of one.
* If at this point you press [SCOPE] (BANK [8]), the (E)
indication in the display will disappear, and you will
enter the corresponding Temporary Scope (refer to the
previous section).
3
When you press [VELOCITY ASSIGN], [CON-
TROL ASSIGN] or [EXIT], you will return to the
Edit Scope page.