Denso QK20-R User Manual page 64

2d code scanner (fixed type)

Table of Contents

Code 39

Code data read will be transmitted as is.

You can select whether or not to transmit start and stop codes ("*").

Interleaved 2of5

The scanner transmits code data read, starting from the character following the start code to the one preceding the stop

code. No start/stop codes will be transmitted.

Codabar (NW-7)

The scanner transmits code data read including the start/stop codes. You can select whether or not to transmit

start/stop codes.

Code 128 (GS1-128 (EAN-128))

The scanner transmits code data read, starting from the character following the start code to the one preceding the

check digit. Start/stop codes, FNC codes, or check digit will not be transmitted. Note that FNC1 placed in character

positions other than the 1st and 2nd ones from the start code will be converted to GS (1Dh) and transferred.

The conversion to the GTIN format is also selectable. For the GTIN format conversion, refer to Section 9.5.

Code 93

The scanner transmits code data read, excluding start and stop codes and a check digit.

RSS (GS1 DataBar)

Code data read will be transmitted as is.

The conversion to the GTIN format is also selectable. For the GTIN format conversion, refer to Section 9.5.

RSS (GS1 DataBar) Composite symbols

Code data read will be transmitted as is.

Under the conditions "Code ID mark: Type 1" and "Code ID mark output mode: Separating," a separator (GS: 1Dh)

and 2D code ID mark are inserted between the linear component and 2D Composite component. (For details about the

code ID mark, refer to (5) Code ID mark on pages 43 to 48.)

Under the conditions "Code ID mark: Type 4" and "Linear component length (RSS/EAN-128): Variable," a separator

(GS: 1Dh) is inserted between the linear component and 2D Composite component.

UPC/EAN Composite symbols

Code data read will be transmitted as is.

You can select whether or not to transmit a check digit of the linear component (UPC/EAN).

Under the conditions "Code ID mark: Type 1" and "Code ID mark output mode: Separating," a separator (GS: 1Dh)

and 2D code ID mark are inserted between the linear component and 2D Composite component.

Under the conditions "Code ID mark: Type 2," the 2D code ID mark is inserted between the linear component and 2D

Composite component. (For details about the code ID mark, refer to (5) Code ID mark on pages 43 to 48.)

Table of Contents

Qk20-u