Table of Contents
Advertisement
Windows Vista
(1) Switch the computer on to run Windows Vista. Log on as an Administrator.
(2) Connect the scanner's USB interface cable to the computer or USB hub.
(3) Wait for the Installing device driver software hint to pop
up on the Windows task tray.
Windows will automatically configure the scanner. Upon
completion of the configuration, the screen shown at left
automatically disappears.
(4) Wait for the USB Human Interface Device hint to pop up
on the task tray.
(5) To check whether the USB device is working normally, open
the Windows Device Manager.
If USB Human Interface Device is added to the sub-tree of
Human Interface Devices as shown at left, the scanner is
connected normally.
If the device is not added or it is marked with
remove this driver with the uninstaller, reboot your
computer, and perform the above connection process again.
13
or
,
Advertisement
Table of Contents
