Set Up Instructions - Stamina AVARI Upright Bike Owner's Manual

SET UP INSTRUCTIONS

Place the AVARI® Upright Bike in the area where it will be used. It is recommended that the AVARI®
Upright Bike be placed on an equipment mat. The AVARI® Upright Bike is approximately 35 inches
long x 22.6 inches wide x 48.5 inches tall. (These dimensions may vary up to one inch.) An area 4 feet
wide x 5 feet long is required for safe operation of the AVARI® Upright Bike. Make sure that adequate
space is available for access to and passage around the AVARI® Upright Bike.
LEVELING: Adjust the LEVELING CAPS(38) on the REAR STABILIZER(3) so the bike sits on the
floor without rocking. Remove and reposition the LEVELING CAPS(38) on the REAR
STABILIZER(3) to level the AVARI® Upright Bike.
MOVING: The AVARI® Upright Bike must be lifted to be moved. Two people are required to grasp
the HANDLEBAR(5) and the REAR STABILIZER(3), lift and move.
FUNCTION INSPECTION:
Visually inspect the AVARI® Upright Bike to verify that assembly is as shown in the above illustration.
Check the function of the AVARI® Upright Bike by turning the crank slowly through one complete
revolution to verify that the drive train functions properly. Adjust the TENSION KNOB(23) and verify that
it functions properly.
CAUTION: Locate and read the WARNING LABEL(59) on the AVARI® Upright Bike. Make sure that all
users read the WARNING LABEL(59) before using the product.
Equipment Mat
(not included)
11
Meijer.com