Set Up Instructions - Stamina 55-1779 ELLIPTICAL Owner's Manual

SET UP INSTRUCTIONS

Place the 55-1779 ELLIPTICAL in the area where it will be used. The max. operation dimensions of
55-1779 ELLIPTICAL are approximately 64 5/8" long x 24 3/4" wide x 64 5/8" tall. (These dimensions may
vary up to one inch.) An area 4 feet wide x 7 feet long is required for safe operation of the 55-1779
ELLIPTICAL. Make sure that adequate space is available for access to and passage around the 55-1779
ELLIPTICAL.
LEVELING: Adjust the LEVELING STANDS(55) under the FRONT STABILIZER on the MAIN FRAME(1)
so that the Elliptical / Stepper sets on the floor without rocking. Refer the instructions below
the illustration.
MOVING: The 55-1779 ELLIPTICAL has a pair of MOVING WHEELS(54) built into the REAR
STABILIZER(2) at the back. Grasp the FRONT STABILIZER and tip the 55-1779 ELLIPTICAL
backward to move.
Equipment Mat
FUNCTION INSPECTION:
Visually inspect the 55-1779 ELLIPTICAL to verify that assembly is as shown in the above illustration.
Check the function of the 55-1779 ELLIPTICAL. Stand on the foot pedals and place your hands at a
comfortable position on the handlebars. Slowly move your highest foot forward and follow the natural path
of the machine. Turn the crank slowly through one complete revolution to verify that the drive train functions
properly. Use the "
System provides different tensions. Refer to the COMPUTER INSTRUCTIONS on pages 12 to 20.
Locate and read the WARNING LABEL(93) on the 55-1779 ELLIPTICAL. Make sure that all
CAUTION:
users read the WARNING LABEL(93).
/ " buttons on the COMPUTER(36) to select a program and verify that the Magnetic
Loosen the NUTS(M8x1.25)(88) to touch the
LEVELING STANDS(55). Adjust the LEVELING
STANDS(55) for leveling. Tighten the NUTS
(M8x1.25)(88) securely against the FRONT
STABILIZER to lock the stand in position.
10