Set Up Instructions - Stamina 55-1610F Owner's Manual

SET UP INSTRUCTIONS

Place the InMotion® E1000 Compact Strider in the area where it will be used. It is recommended that
the InMotion® E1000 Compact Strider be placed on an equipment mat. The InMotion® E1000 Compact
Strider is approximately 24.3 inches long x 17 inches wide x 11.4 inches tall. (These dimensions may vary
up to one inch.) Make sure that adequate space is available for access to, passage around and emergency
dismount from the InMotion® E1000 Compact Strider. A minimum of 20 inches on at least one side and
20 inches either behind or in front of the InMotion® E1000 Compact Strider is required for safe operation.
LEVELING: Adjust the location of InMotion® E1000 Compact Strider to ensure InMotion® E1000
Compact Strider sits on the floor without rocking.
MOVING: Grasp the REAR STABILIZER(2) to move the InMotion® E1000 Compact Strider. Do not
use the PEDAL ARMS(3, 4) to move the InMotion® E1000 Compact Strider. The PEDAL
ARMS(3, 4) will move and may pinch your hand or fingers.
FUNCTION INSPECTION:
Visually inspect the InMotion® E1000 Compact Strider to verify that assembly is as shown in the above
illustration. Check the function of the InMotion® E1000 Compact Strider. If you have good balance and
are familiar with the InMotion® E1000 Compact Strider, stand on the foot pedals. If you do not have
good balance, sit in a chair and place feet on the foot pedals. Slowly move your highest foot forward and
follow the natural path of the machine. Turn the crank slowly through one complete revolution to verify that
the drive train functions properly. Adjust the TENSION KNOB(21) and verify that the resistance changes.
CAUTION: Locate and read the CAUTION LABEL(55) on the InMotion® E1000 Compact Strider.
Make sure that all users read the CAUTION LABEL(55).
Equipment Mat
9