Set Up Instructions - Stamina InMotion 55-1618B Owner's Manual

SET UP INSTRUCTIONS

Place the InMotion® Compact Strider in the area where it will be used. It is recommended that the
InMotion® Compact Strider be placed on an equipment mat. The InMotion® Compact Strider is
approximately 24.3 inches long x 17.5 inches wide x 11.4 inches tall. (These dimensions may vary up to
one inch.) Make sure that adequate space is available for access to move around and emergency dismount
from the InMotion® Compact Strider. A minimum of 20 inches on at least one side and 20 inches either
behind or in front of the InMotion® Compact Strider is required for safe operation.
LEVELING: Adjust the location of InMotion® Compact Strider to ensure InMotion® Compact Strider
sits on the floor without rocking.
MOVING: Grasp the handle on the top of the product to move the InMotion® Compact Strider. Do
not use the PEDAL ARMS(3,4) to move the InMotion® Compact Strider. The PEDAL
ARMS(3,4) will move and may pinch your hand or fingers.
FUNCTION INSPECTION:
Visually inspect the InMotion® Compact Strider to verify that assembly is as shown in the above illustration.
Check the function of the InMotion® Compact Strider. If you have good balance and are familiar with
the InMotion® Compact Strider, stand on the foot pedals. If you do not have good balance, sit in a chair
and place feet on the foot pedals. Slowly move your highest foot forward and follow the natural path of
the machine. Turn the crank slowly through one complete revolution to verify that the drive train functions
properly. Adjust the TENSION KNOB(21) and verify that the resistance changes.
CAUTION: Locate and read the CAUTION LABEL(55) on the InMotion® Compact Strider. Make sure
that all users read the CAUTION LABEL(55).
Handle
9
Equipment Mat