Set Up Instructions - Stamina 55-1631 Owner's Manual

SET UP INSTRUCTIONS

Place the InMotion® Compact Strider Pro in the area where it will be used. It is recommended that the
InMotion® Compact Strider Pro be placed on an equipment mat. The maximum operation dimensions of
the InMotion® Compact Strider Pro are approximately 25.5 inches long x 16.7 inches wide x 47.6 inches
tall. (These dimensions may vary up to one inch.) Make sure that adequate space is available for access
to, passage around and emergency dismount from the InMotion® Compact Strider Pro. A minimum of
20 inches on at least one side and 20 inches either behind or in front of the InMotion® Compact Strider
Pro is required for safe operation.
LEVELING: Adjust the location of InMotion® Compact Strider Pro to ensure InMotion® Compact
Strider Pro sits on the floor without rocking.
MOVING: Grasp the handle on the top of the product and the HANDLEBAR POST(59) to move the
InMotion® Compact Strider Pro. Do not use the PEDAL ARMS(51, 40) to move the
InMotion® Compact Strider Pro. The PEDAL ARMS(51, 40) will move and may pinch
your hand or fingers.
FUNCTION INSPECTION:
Visually inspect the InMotion® Compact Strider Pro to verify that assembly is as shown in the above
illustration. Check the function of the InMotion® Compact Strider Pro. Stand on the foot pedals. Slowly
move your highest foot forward and follow the natural path of the machine. Turn the crank slowly through
one complete revolution to verify that the drive train functions properly. Adjust the TENSION KNOB(13)
and verify that it functions properly and verify that the resistance changes.
CAUTION: Locate and read the WARNING LABEL(70) on the InMotion® Compact Strider Pro. Make
sure that all users read the WARNING LABEL(70).
Equipment Mat
10