Table of Contents
Advertisement
8. Put on the supplied gloves before pushing upward the main body into the top housing. Make
sure the red triangle
outside of the main body. Push the main body upward into the top housing until the orange
catches on both sides click into position.
Main Body
Note:
1. To release the main body, press the two orange release buttons on both sides. Make sure
you are holding the main body firmly, otherwise it will fall down.
2. To protect the glass dome from getting dirty and scraped up, please put on the supplied
gloves before installing.
9. Screw the housing cover to the top housing slowly by twisting it clockwise.
Note: When you turn on the power, the camera will enter self-inspection mode and run a
self-testing program. Once this is complete, you will be able to operate it via any IP network.
on the inside of the top housing lines up with the red triangle on the
Top Housing
12
EPN Plus Series
Advertisement
Table of Contents
