To Make Changes To Settings - Robertshaw RS4110 User Manual

If a button is not pushed within 30 seconds the thermostat returns to
operation.
Use the
Push EDIT SCHEDULE to move to minutes.
Use the
Push EDIT SCHEDULE to move to the heat or cool temperature setting.
Use the
Pressing
to change the setpoint.
- OR -
Push EDIT SCHEDULE to move from heat to cool or cool to heat
temperature setting. Use the
setpoint.
NOTE: THE HEATING AND COOLING SETPOINTS
CANNOT BE ENTERED AS CROSSED. THAT IS, THE
COOLING SETPOINT CANNOT BE LOWER THAN THE
HEATING SETPOINT.
Push EDIT SCHEDULE and repeat this process for the remaining three
weekday settings. All of the week days will use this schedule.
After the weekday schedule is complete the display will show the
weekend schedule.
Continue the same steps to program the four weekend settings.
When you are finished, the thermostat will be in operation after 30
seconds.
To Make Changes to the Settings
When and
display the current settings in order.
To change any setting:
When the setting is visible and flashing press the
arrows to adjust the number on the screen.
To exit the changes and save:
press START/STOP SCHEDULE. The thermostat will return to
operation.
SCAL = Scale in °F (Fahrenheit) or °C (Celsius)
or to change the hour of the start time if desired.
or to change the minutes of the start time if desired.
or to change the temperature setpoint.
will switch between cooling and heating. Use
are pressed at the same time the thermostat will
or to change the temperature
7
and
or