Kawai K5000S Owner's Manual page 58

ASSIGNABLE CONTROLLER
Two additional controllers can be used for modulation. The controllers are as-
signed from the following screen.
L1
L2
L3
L4
L1 SOURCE1
Selects the source for the modulation. The source can be any of those listed
below.
L2 DESTINATION1
Selects the destination for the modulation. The destination can be any of
those listed on page !!!.
L3 DEPTH1
Sets the amount of the modulation. This can be positive or negative.
R1 SOURCE2
Selects the source for the modulation. The source can be any of those listed
below.
R2 DESTINATION2
Selects the destination for the modulation. The destination can be any of
those listed on page !!!.
R3 DEPTH2
Sets the amount of the modulation. This can be positive or negative.
ASSIGNABLE CONTROLLER SOURCES
The following sources can be used for modulation:
BENDER
The Pitch Bend wheel.
CH PRESS (CHANNEL PRESSURE)
Aftertouch pressure (per channel).
WHEEL
The Modulation Wheel
EXPRESS (EXPRESSION PEDAL)
The Expression Pedal, MIDI Controller 11
MIDI VOLUME
The MIDI Volume command, MIDI Controller 7
PANPOT
The MIDI Pan command, MIDI Controller 10
G CONT 1 ~ 8 (GENERAL CONTROLLERS 1~ 8)
The eight MIDI General Purpose Controllers – controller numbers 16–19
& 80–83.
5 8
A006 Reznator
> Source1 Bender
> Dest1 Pitch
> Depth1
Back S1 P S2-- S3 A S4 A S5-- S6--
F1 F2 F3
KAWAI K5000S ADVANCED ADDITIVE SYNTHESIZER
Assignable Controller
Source2 Ch Press <
Dest2 Vibrato Dp <
+31 Depth2
F4 F5 F6
+12 <
F7 F8
R1
R2
R3
R4