Installer Guide; Getting Started; Typical Appliance System - Heat & Glo Escape-42DV Owner's Manual

4 4

Getting Started

A. Typical Appliance System
NOTICE: Illustrations and photos refl ect typical installations and are for design purposes only. Illustrations/diagrams are not
drawn to scale. Actual product may vary from pictures in manual
NON-COMBUSTIBLE ROOF FLASHING
MAINTAINS MINIMUM CLEARANCE
AROUND PIPE (SECTION 10.E)
VENT PIPE (SECTIONS 7 and 8)
CEILING FIRESTOP
ON FLOOR OF ATTIC
(SECTION 8.C )
FRAMING/HEADER
(SECTION 5.C .)
GAS LINE
(SECTION 11)
Figure 4.1 Typical System
16

Installer Guide

Heat & Glo • Escape-42DV • 2052-900 Rev. X • 3/11
VERTICAL TERMINATION CAP
(SECTION 10.G)
STORM COLLAR
(SECTION 10.F )
VENT PIPE PENETRATES ROOF
PREFERABLY WITHOUT AFFECTING
ROOF RAFTERS (SECTION 8.C)
ATTIC INSULATION SHIELD (NOT
SHOWN) MUST BE USED HERE TO
KEEP INSULATION AWAY FROM
VENT PIPE IF ATTIC IS INSULATED
(SECTION 8.D)
FRAMING HEADED OFF
IN CEILING JOISTS
(SECTION 8.C )
MANTEL AND
MANTEL LEG
(SECTIONS 5.D
and 13.B)
HEARTH EXTENSION
OPTIONAL
WALL SWITCH
SURROUND