Lens Assembly Replacement - Chauvet SlimPAR Pro VW User Manual

Lens Assembly
Replacement
Page 10 of 18
The SlimPAR™ Pro VW comes with a factory-installed wide-angle lens assembly. A
narrow lens (17°) assembly is available as an optional accessory (SPPVWLENS17).
This narrow lens assembly will alter the beam and field angles of the fixture.
To replace the lens assembly, follow the instructions below.
1. Remove the four Allen screws from the front trim ring with a #3 metric Allen wrench.
2. Remove the front cover (with glass still attached to the ring).
3. You now have access to the lens assembly. Use a Philips-head screwdriver to
remove the five screws that hold it in place.
4. Carefully remove the lens assembly. The LEDs and circuit board will now be
exposed. Use caution to prevent damaging them.
5. Place the new lens assembly in the fixture and reinstall the five Philips screws.
Tighten screws as simultaneously as possible to the same tension. Do not over-
tighten the screws as this could cause damage.
6. Put the front cover in place and reinstall the five Allen screws.
Allen Screw
Allen Screw
Lens
Front Cover
Assembly
SlimPAR™ Pro VW User Manual Rev. 6
Allen Screw
Allen Screw