Setup; Ac Power; Fuse Replacement; Fixture Linking - Chauvet Legend 1200E SPOT User Manual
Moving yoke fixture with a 1200 w short arc discharge lamp
Hide thumbs
Also See for Legend 1200E SPOT:
- User manual (36 pages) ,
- Quick reference manual (4 pages) ,
- User manual (30 pages)
Table of Contents
Advertisement
Setup
3. Setup
AC Power
Fuse
Replacement
Fixture
Linking
Legend™ 1200E Spot User Manual
This fixture has an auto-switching power supply that can work with an input
voltage range of 200~240 VAC, 50/60 Hz.
Always connect the fixture to a protected circuit with an appropriate electrical
ground to avoid the risk of electrocution or fire.
To determine the power requirements for a particular fixture, see the label affixed
to the back plate of the fixture or refer to the fixture's specifications chart. A
fixture's listed current rating indicates its average current draw under normal
conditions.
Never connect the fixture to a rheostat (variable resistor) or dimmer circuit,
even if the rheostat or dimmer channel serves only as a 0 to 100% switch.
1.
With a Phillips #2 screwdriver, unscrew the fuse holder from its housing.
2.
Remove the damaged fuse from its holder and replace with exact same
type and rating fuse.
3.
Screw the fuse holder back in its place and reconnect power.
Disconnect the power cord before replacing the fuse and always replace it
with a fuse of the same type and rating.
If using multiple DMX compatible fixtures, it is possible to control them individually
with a single DMX controller or to run them synchronized in a master/slave
operating mode. DMX compatible fixtures use a serial data link between them.
The connection between fixtures follows a daisy chain pattern (the DMX output of
a fixture connects to the DMX input of the next fixture, and so on).
When using a DMX controller, the combined number of channels required by all
the fixtures on the serial data link determines the number of fixtures the DMX
controller can support.
To comply with the EIA-485 standard, which is the base for the DMX standard,
do not connect more than 32 fixtures without using a DMX optically-isolated
splitter. Doing otherwise may result in deterioration of the digital DMX signal.
8
The fuse is located
inside this
compartment.
FUSE
8/13/2009 10:57 AM
Advertisement
Table of Contents
