Setup; Ac Power - Chauvet Followspot 1200 Quick Start Manual

Setup

3. Setup

AC Power

Power
Requirements
Power Cord
Fuse
Replacement
Fuse Holder
Diagram
4
The Followspot 1200 has two AC input voltage settings, 208 and 230 VAC,
and two AC frequency settings, 50 and 60 Hz. The voltage and frequency
settings require changing the connections on the corresponding terminal
strip. See the Voltage and Frequency Selection section in this chapter.
Make sure that you are connecting the Followspot 1200 to the proper
voltage, as per the specifications in this guide, the product's manual or on
the product's sticker.
Always connect the Followspot 1200 to a protected circuit with an
appropriate electrical ground to avoid the risk of electrocution or fire.
To determine the power requirements for the Followspot 1200 see the
sticker affixed to the product. Alternatively, you may refer to the Technical
Specifications chart in the Technical Information chapter of this guide.
The listed current rating indicates the maximum current draw during normal
operation. Please refer to the Sizing the Circuit Breakers section in the
Appendix chapter of the Followspot 1200 user manual.
The Followspot comes with a bare ended power cord. Use the table below
to wire the appropriate plug to the power cord.
Connection Wire (US)
AC Live
AC Neutral
AC Ground Green/Yellow
Never connect the Followspot 1200 to a rheostat (variable resistor) or
dimmer circuit, even if the rheostat or dimmer channel serves only as
a 0 to 100% switch.
Make sure to disconnect the product's power cord before replacing a
blown fuse, and always replace it with a fuse of the same type and
rating.
1) With a Phillips #2 head screwdriver, unscrew the fuse holder cap from its
housing.
2) Remove the blown fuse from the fuse holder cap and replace it with a
good fuse of the exact same type and rating.
3) Screw the fuse holder cap back in its place and reconnect power.
Illuminated
On/off Switch
Fuse Holder
Wire (Europe)
Black Brown
White Blue
Green/Yellow
Followspot 1200 Quick Start Guide Rev. 3
Pin Screw
1 Yellow/Brass
2 Silver
3 Green
Power Cord
Rubber Boot