Replacing Gobos - Chauvet Legend 1200E SPOT User Manual

Replacing Gobos

Legend™ 1200E Spot User Manual
This fixture comes with slot-n-lock gobo wheels for easy gobo
replacement/installation. Please see the diagram, along with the set of instructions,
below for further explanation.
1. Unscrew the four ¼- turn screws (S2) to detach the front cover.
2. Remove the slot-n-lock gobo single assembly. Using your thumb and forefinger,
grasp the slot-n-lock gobo assembly and remove it from the gobo wheel.
3. Using a small prying tool, remove the gobo tension ring and remove it from the
gobo aperture.
Push the gobo with your finger from the back side following the same direction that
the tension ring was removed.
You should use cotton or latex gloves to avoid from touching the gobos with
your bare hands.
The tension ring could pop out abruptly and fall inside the fixture. Use caution
when removing it and, if necessary, use both hands.
Replace the slot-n-lock prism(s) on the prism/effect wheel using the same
method as the rotating gobo wheel.
15
S2
slot-n-lock gobo
single assembly
Setup
8/13/2009 10:57 AM