Table of Contents
Advertisement
Setup
3. Setup
AC Power
AC Plug
Fuse Replacement
-6-
Each COLORdash™ Batten-Quad 12 has an auto-ranging power supply that works with
an input voltage range of 100~240 VAC, 50/60 Hz. To determine the power
requirements for each COLORdash™ Batten-Quad 12, refer to the label affixed to the
product. You can also refer to the
The listed current rating indicates the maximum current draw during normal operation.
For more information, you may download Sizing Circuit Breakers from the CHAUVET®
website: www.chauvetpro.com.
Always connect this product to a protected circuit with an appropriate electrical
ground to avoid the risk of electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0 to 100% switch.
The COLORdash™ Batten-Quad 12 comes with a power input cord terminated with a
Neutrik® powerCON® connector on one end and an Edison plug on the other end (U.S.
market). If the power input cord that came with your product has no plug, or if you need
to change the Edison plug, use the table below to wire the new plug.
Connection
AC Live
AC Neutral
AC Ground
Make sure to disconnect the product's power cord before replacing a blown fuse.
Always replace the blown fuse with another of the same type and rating.
1. Disconnect this product from the power outlet.
2. Using a #2 flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove the blown fuse and replace with a another fuse of the same type and rating
(2 A, 250 V).
4. Screw the fuse holder cap back in place and reconnect power.
Technical Specifications
Wire (U.S.)
Wire (Europe)
Black
White
Green/Yellow
Green/Yellow
COLORdash™ Batten-Quad 12 User Manual Rev. 3
chart in this manual.
Screw Color
Brown
Yellow or Brass
Blue
Silver
Green
Advertisement
Table of Contents
