Min Copy Memory; Numpad Job Assist; Format Fax Storage; Adf Edge Erase - Lexmark X264dn Service Manual

Min Copy Memory

This setting allocates the amount of DRAM memory to be used for storing copy jobs in the queue. 25, 35, 50, 80
and 100 MB are the available settings. To adjust the minimum copy memory, perform the following steps:
1.
In the configuration menu, scroll to the MinCopy Memory item, and press
2.
Use the
3.
When the desired value is displayed, press

NumPad Job Assist

This setting determines if a user can configure and initiate a job using the operator panels hard buttons. When
activated, a user can choose a function (copy, fax, etc...), enter specific values for a limited number of settings
and then initiate the job with a series of key presses. The values for this setting are On and Off. The default for
this setting is Off.

Format Fax Storage

This setting allows the user to format non-volatile fax storage memory. While formatting is taking place,
Formatting Fax Flash DO NOT POWER OFF appears. After formatting is complete, the display reverts to the main
menu.

ADF Edge Erase

This menu item sets the size, in millimeters, of the no-print area around an ADF scan job. All copy jobs have a
minimum of a two-millimeter border. Copy jobs will use the setting or two millimeters, whichever is larger.
To adjust the ADF edge erase setting, perform the following steps:
1.
In the Configuration menu, select the ADF Edge Erase menu item.
2.
Press
3.
When the desired value is displayed, press
or to increase or decrease the setting's value.
or to increase or decrease the setting's value.
.
.
7013-XXX
.
3-29
Diagnostic aids