Speaker
Description
Speaker
The speaker is attached to the front of the chassis under the rotating drive cage.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Rotate the drive cage to its upright position.
5.
Disconnect the speaker wire from the white system board labeled SPKR (1).
6.
Remove the Torx screw that secures the speaker to the chassis (2).
7.
Lift the speaker from the inside of the chassis to remove it (3).
Figure 7-33
To install the speaker, reverse the removal procedures.
(Access Panel on page
(Front Bezel on page
Removing the speaker
(Preparation for Disassembly on page
95).
96).
Spare part number
636925-001
94).
Speaker 125