Front I/O, Power Switch Assembly
Description
Front I/O and power switch assembly
The front I/O and power switch/LEDs is one assembly, attached to the front of the chassis. Push the
assembly into the chassis to remove.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Remove the chassis fan
5.
Rotate the drive cage to its upright position.
6.
Disconnect the four cables from the system board as follows:
●
Yellow connector labeled FRONT_USB
●
Green connector labeled FRONT_USB2
●
Blue connector labeled FRONT AUD
●
Black connector labeled PB/LED
Figure 7-31
7.
Remove the Torx T15 screw (1) that secures the assembly to the front of the chassis.
(Access Panel on page
(Front Bezel on page
(Front Fan Assembly on page
Disconnecting the front I/O, power switch/LED assembly cables
(Preparation for Disassembly on page
95).
96).
120).
Front I/O, Power Switch Assembly 123
Spare part number
636926-001
94).