Table 8: Basic Settings - Grandstream Networks HT503 User Manual

NAT
Port Status
End User Password
Web Port
Telnet Server
IP Address
DHCP hostname
DHCP domain
DHCP vendor class ID
PPPoE account ID
PPPoE password
PPPoE Service name
Preferred DNS
Time Zone
FIRMWARE VERSION 1.0.6.8
This shows what kind of NAT the HT503 is connected to. It is based on STUN
protocol. If the detected NAT is symmetric NAT, STUN will not work and Outbound
Proxy needed to make HT503 functioning correctly.
Displays information regarding the individual FXS ports.
Port Hook Registration
FXS On Hook Registered
FXO Idle Registered
• Both FXS port and FXO port are registered with this SIP Server.
• FXS Port user has set Do Not Disturb.
• FXS Port user has set his calls to be forwarded unconditionally to ext 613.
FXO Port user has set his calls to forward to 614 when his phone is busy.

Table 8: BASIC SETTINGS

This contains the password for end user to access the Web Configuration Menu. User
can put new password here. This field is case sensitive with maximum of 25 characters
This is the device's internal HTTP server port. Default is 80.
Default is set to YES. Telnet access is allowed to the device in this case. Used only for
special purposes such as debugging and troubleshooting. List of available commands
will be shown by pressing >help command from telnet console.
• If DHCP mode is enabled, then all the field values for the Static IP mode are not
used (even though they are still saved in the Flash memory.) The HT503 will acquire
its IP address from DHCP in the network.
• PPPoE settings are usually for DSL/ADSL modem users. The HT503 will attempt to
establish a PPPoE session if PPPoE account is set.
• If Static IP mode is selected, the IP address, Subnet Mask, Default Router IP
address, DNS Server 1 (mandatory), DNS Server 2 (optional) fields need to be
configured.
This option specifies the name of the client. This field is optional but may be required
by some Internet Service Providers. Default is blank.
This option specifies the domain name that client should use when resolving
hostnames via the Domain Name System. Default is blank.
This option is used by clients and servers to exchange vendor-specific information.
Default is blank.
PPPoE username. Necessary if your ISP requires you to use a PPPoE (Point to Point
Protocol over Ethernet) connection
PPPoE account password
This field is optional. If your ISP uses a service name for the PPPoE connection, enter
the service name here. Default is blank.
The address of your preferred DNS server.
This parameter controls how the displayed date/time will be adjusted according to the
specified time zone.
HT503 USER MANUAL
DND Forward Busy
Forward
Yes 613
No 614
Delayed
Forward
Page 25 of 48