Grandstream Networks HT503 User Manual page 29

HTTP/HTTPS The password for the HTTP/HTTPS server.
Password
Firmware File Default is blank. If configured, HT503 will request the firmware file with the prefix. This
Prefix setting is useful for ITSPs. End user should keep it blank.
Firmware File Default is blank. End users should keep it blank.
Postfix
Config File Prefix Default is blank. End users should keep it blank.
Config File Postfix Default is blank. End users should keep it blank.
If set to "Yes", configuration and upgrade server information can be obtained using DHCP
Allow DHCP option
option 66 from DHCP server located in customer's environment
66 to override
server
Choose "Yes" to enable automatic upgrade and provisioning. When set to No, HT503 will
Automatic Upgrade
only do upgrade once at boot up.
When "Check every day" or "Check every week" is checked, user can specify "Hour of the
day(0-23)" or "Day of the week(0-6)". Default time is Monday 1AM.
There are three options to choose from: "Always check for New Firmware at Boot up", "Check
New Firmware only when F/W pre/suffix changes", and "Always Skip the Firmware Check".
This protects the configuration from an unauthorized change. If set to "Yes, the configuration
Authenticate Conf
File file is authenticated before acceptance.
Firmware Key Key for firmware encryption. (32 digits in hexadecimal format. End users should keep it blank.
SSL Certificate The user specified SSL certificate used for SIP over TLS in X.509 format.
SSL Private Key The user specified SSL private key used for SIP over TLS in X.509 format.
SSL Private Key User specified password to protect the private key above.
Password
User specify the Auto Configuration Server's URL (TR-069 protocol)
ACS URL
ACS Username User specify the ACS Username
ACS Password User specify the ACS password
Periodic Inform Default is No. If set to YES, device will send inform packets to the ACS
Enable
Periodic Inform Frequency that the inform packets will be sent out to the ACS
Interval
Connection Set a user name for the ACS to connect to this device
Request Username
Connection Set a password for the ACS to connect to this device
Request Password
System Ring Configuration option for FXS port ring cadence for all incoming calls. (Syntax: c=on1/off1-
Cadence
on2/off2-on3/off3; )
Note : Maximum supported cadences is 3
Call Progress Using these settings, users can configure tone frequencies according to their preference. By
Tones
default they are set to North American frequencies.
These tones should be configured with known values to avoid uncomfortable high pitch
sounds. ON is the period of ringing ("On time" in 'ms') while OFF is the period of silence. In
order to set a continuous tone, OFF should be zero. Otherwise it will ring ON ms and a pause
of OFF ms and then repeat the pattern.
Example for North America Dial Plan:
f1=350@-13,f2=440@-13,c=0/0;
FIRMWARE VERSION 1.0.6.8
HT503 USER MANUAL
Page 29 of 48