Saving The Configuration Changes; Rebooting From Remote; Configuration Through A Central Server - Grandstream Networks HT503 User Manual

Inter Digit Timeout
Wait for Dial Tone
Stage Method (1/2)

SAVING THE CONFIGURATION CHANGES

After user makes a change to the configuration, press the "Update" button in the Configuration Menu. The
web browser will then display a message window to confirm saved changes, press "Apply" button to
confirm.
Grandstream recommends reboot or power cycle the IP phone after saving changes

REBOOTING FROM REMOTE

Press the "Reboot" button at the bottom of the configuration menu to reboot the phone remotely. The web
browser will then display a message window to confirm that reboot is underway. Wait 30 seconds to log in
again.

CONFIGURATION THROUGH A CENTRAL SERVER

Grandstream HT503 can be automatically configured from a central provisioning system.
When HT503 boot up, it will send TFTP or HTTP/HTTPS request to download configuration file,
"cfg000b82xxxxxx" or "cfg00082xxxxxx.xml", where "000b82xxxxxx" is the LAN MAC address of the
HT503. It will first request "cfg000b82xxxxxx" then "cfg000b82xxxxxx.xml"
A service provider or an enterprise with large deployment of Grandstream devices can easily manage the
configuration and service provisioning of individual devices remotely from a central server.
Grandstream has a central provisioning system called GAPS (Grandstream Automated Provisioning
System). GAPS supports automatic configuration of Grandstream devices. GAPS uses enhanced (NAT
friendly) TFTP or HTTP (thus no NAT issues) and other communication protocols to communicate with
each individual Grandstream device.
Grandstream provides GAPS service to VoIP service providers. Use GAPS for either simple redirection
or with certain special provisioning settings. At boot-up, Grandstream devices by default point to
Grandstream provisioning server GAPS, based on the unique MAC address of each device, GAPS
provision the devices with redirection settings so that they will be redirected to customer's TFTP or HTTP
server for further provisioning. Grandstream also provide configuration tool to facilitate the task of
generating device configuration files.
The tool and
http://www.grandstream.com/support/tools
FIRMWARE VERSION 1.0.6.8
When dialing from the PSTN to VoIP, subsequent digits have to be input within the
period of inter-digit timeout. Otherwise the dial plan thinks it is the end of the digit input.
Wait for Dial tone is used for one stage VoIP to PSTN calls. If set to Yes, the device
will first obtain a PSTN line and a dial tone from a central office. After obtaining the dial
tone, the digits dialed will be sent to the central office.
This configuration is applicable for VoIP to PSTN calls and indicates one or two stage
dialing methods.
configuration template
.
HT503 USER MANUAL
are available for download from
Page 43 of 48