Additional copy operations
3.5
Copying with programmed copy settings (Mode Memory)
Programmed copy settings can be recalled to be used again for copying.
1
Position the original to be copied.
–
For details on positioning the original, refer to
2
Press the [Mode Memory] key.
The Recall Copy Program screen appears.
3
Touch the button for the copy program registered with the copy settings to be recalled.
–
If the copy settings in the selected copy program are not to be checked, continue with step 8.
–
If the copy program to be recalled is not displayed, touch [↑] and [↓] until the desired copy program
is displayed.
4
Press the [Check Program Settings] key.
–
The copy settings cannot be changed from the Check Job Settings screens.
Océ cm3522/cm2522
"Feeding the original" on page
3
2-6.
3-12