Far End Control; Point To Point - TANDBERG 880 MXP User Manual

MBTelehealth – Tandberg 880 MXP User Guide
2. When the volume is turned off, the volume indicator
Press the Volume + key to remove the indicator.
During a conference, all sites should be muted with the exception of the
presenter's site. If the participants at the far end are having trouble hearing you,
they may need to adjust their volume or you may need to adjust yours. Make
sure that the volume on the monitor is on. It should be adjusted to the halfway
point as shown below.
6.0

FAR END CONTROL

6.1 Point to Point

Taking Far End Camera Control allows you to move the camera at the far end site as
well as control their video sources and presets during Point- to- Point calls only.
However, you cannot save far end camera presets.
Before taking far end camera control, always request permission first and explain why
you are taking control. You may need to take far end camera control if:
There is an unskilled operator at the far end.
The operator requests that you take control.
If the operator isn't able to facilitate the event at their end.
To use far end camera control during a call:
1. Press the Far End button
2. Move the camera to the desired position using the directional arrows on the
remote control. Zoom in and out on the person or item you want to see.
3. Press the Far End button again to turn far end control off
Taking far end control of the camera may not always work especially if you are
using a Tandberg videoconferencing system and the far end site is using a
Polycom videoconferencing system (or visa versa) as they use different
protocols. If having far end camera control is important during the session,
disconnect from the call, re-establish the connection and try to take far end
camera control again.
Remote Control Volume Indicator
Screen/Monitor Volume Indicator
on the remote control.
Page 12 of 31
will appear onscreen.