General Setup And Use; General Setup - TANDBERG 880 MXP User Manual

MBTelehealth – Tandberg 880 MXP User Guide
3.0

GENERAL SETUP AND USE

The following sections will provide instructions for setting up and using your Tandberg
880 MXP to place and receive video conference calls. A Cheat Sheet is available in
Appendix A for a quick reference on how to set up and use of your video conference
system.

General Setup

3.1
To setup and use the Tandberg 880 MXP videoconferencing equipment:
1. Position the equipment in the specified location/room
2. Plug the power cord into the wall.
3. Connect the free end of the Ethernet cable to the MBTelehealth jack
4. Turn on the codec, the screen/monitor and the router. After approximately 15-20
seconds you will see the startup screen. . (If the Ethernet cable is connected
correctly, you will see a flashing green VPN light on the front of the Cisco 871
router.)
5. Place the microphone on the table in front of the participants. If possible, position
the microphone at least 6.5 feet in front of the system
6. Press Cancel once then position the camera on the participant(s) using the arrow
keys and the zoom + and - keys.
For more information on setting and storing camera positions see section 3.3
Camera Presets
The Startup Screen
Page 7 of 31