Table of Contents
Advertisement
PC SoftPresenter *
PC SoftPresenter is used to display PC images on your system. The system and your PC must be connected to
a LAN. In addition, VNC (Virtual Network Computing) server software must be installed on the PC.
To show the PC image:
• Start the VNC software on your PC.
• Press P
on your remote control. Use UP/DOWN to activate PAGE UP/PAGE DOWN on the PC.
C
For setup information and details, see 'VNC Settings' in 'Advanced use'.
Far end camera control (FECC)
far end
Press F
E
until the 'FarEndCamera' on-screen indicator is displayed.
AR
ND
For this feature to operate the far end must support 'Far end camera control' (H.281).
While activated you will be able to control the far end's camera (pan/tilt/zoom/focus) and presets.
To control the far end camera use the keys below:
for pan/tilt and
OK
Far end presets can be activated by pressing the keys P1 P2 P3 or the number keys 0-9 to activate presets P0-
P9.
Selection of far end videosources is achieved by pressing the buttons below when in FarEndCamera mode:
vcr
main cam
aux
doc cam
I
NOTE
T DEPENDS ON THE FAR END SYSTEM CONFIGURATION IF THE FAR END DOCUMENT CAMERA IS DISPLAYED WHEN
C
.
AM IS PRESSED
To prevent others controlling your camera, select 'Far End Camera Control:Off' in 'Utilities'.
TANDBERG Videoconferencing System
for zooming.
zoom
pc
27
General use
D
OC
Advertisement
Table of Contents
