General Problems - Canon JX500 User Manual

The Printout Contains Blurred or Smudged Ink
Cause
The paper you are using may not be
supported by the fax.
You may be printing on the wrong side
of the paper.

General Problems

The Fax has no Power
Cause
The power cord may not be plugged in
securely.
The power cord may not be supplying
power.
The Fax will not Print Reports
Cause
The FINE Cartridge may need to be
replaced.
Nothing Appears on the LCD
Cause
The power cord may not be plugged in
securely.
The LCD/LED may be in the Power
Saver mode.
Make sure you are using the recommended paper (see page 16).
Some papers have a "right" side for printing. If the print quality is not as clear as
you would like it to be, try turning the paper over and printing on the other side.
Check that the power cord is plugged securely into the fax and into the wall
outlet (see the Easy Setup Instructions). If the fax is plugged into a power strip,
make sure the power strip is plugged in and turned on.
Check the power cord by substituting with another.
Determine if the problem is with the FINE Cartridge and replace if necessary
(see page 56).
Check that the power cord is plugged securely into the fax and into the wall
outlet (see the Easy Setup Instructions). If the fax is plugged into a power strip,
make sure the power strip is plugged in and turned on. If the LCD remains
blank, unplug the fax, wait five seconds, then plug it in again.
Press any button on the Operation Panel except for [ON/OFF] to restore the
display.
Action
Action
Action
Action
Troubleshooting 73