Forwarding Telephone Messages; Setting The Forwarding Number; Setting The Number Of Redial Times - Canon JX500 User Manual

Forwarding Telephone Messages

This feature allows you to automatically forward telephone messages, recorded when the fax is set
to <TAM MODE>, to a registered forwarding number.
You can use remote control to access the forwarding number and listen to your telephone
messages.
Note
You must register a forwarding number and set <TAM MODE> before you can use this feature. Remote
control cannot be used to set this feature unless a forwarding number has been registered.
If you set <FWD SETTINGS> to <ON> when a forwarding message has not been recorded, you will
hear a tone instead of a forwarding message when telephone messages are forwarded.

Setting the Forwarding Number

1
Press [Menu].
2
Use [ ] or [ ] to select <DATA REGSTRATION>, then press [Start]. The LCD
displays <USER SETTINGS>.
3
Use [ ] or [ ] to select <TAM SETTINGS>, then press [Start]. The LCD displays
<MESSAGE LENGTH>.
4
Use [ ] or [ ] to select <FWD SETTINGS>, then press [Start]. The LCD displays
<OFF>.
5
Use [ ] or [ ] to select <ON>, then press [Start] twice. The LCD displays <TEL=>.
6
Use the numeric buttons to enter the forwarding number, then press [Start].
A maximum of 40 digits can be entered.
7
Press [Stop].
Setting ends and the fax returns to standby mode.

Setting the Number of Redial Times

1
Follow steps 1 to 4 on page 46.
2
Use [ ] or [ ] to select <ON>, then press [Start]. The LCD displays <FWD TEL
NUMBER>.
3
Use [ ] or [ ] to select <AUTO REDIAL>, then press [Start]. The LCD displays
<ON>.
4
Use [ ] or [ ] to select <ON>, then press [Start] twice. The LCD displays
<2TIMES>.
5
Use the numeric buttons, or [ ] or [ ] to enter the number of redial times, then
press [Start] twice. The LCD displays <2MIN.>.
6
Use the numeric buttons, or [ ] or [ ] to enter the redial interval, then press
[Start].
46 Using TAM Mode (FAX-JX500/JX300 only)