Table of Contents
Advertisement
P35i Fireplace Insert
6. Igniter
Vacuum to clean.
Whenever cleaning burn pot air chamber.
To remove igniter;
•
Loosen wing screws and remove cover on front of
burn pot.
•
Using a 5/16" wrench, remove the two black
screws above the cleanout. The igniter and brack-
et are now free.
•
Slide the insert body out of the mounting frame.
•
Locate the pale blue and yellow wires entering at
the bottom of the feeder body.
•
Remove wire ties as needed to loosen the igniter
wires.
•
Pull the igniter and bracket out from the front until
the wire disconnects are accessible.
•
When installing igniter, reverse these steps and be
sure that the plastic coated wires are pulled all the
way to the rear of the feeder.
•
Re- tie all wires clear of all hot or moving parts.
This shows the igniter and bracket removed from the
burn pot. Missing in the illustration is the wires from the
igniter which run through the burn pot air chamber. Only
the first few inches of the wires are insulated for high
temperatures. These insulated wires are all that can be
inside the feeder or burn pot.
Save These Instructions
This hole in the feeder body is where the igniter wires
pass through to the burn pot.
3-90-775
FEED MOTOR
Pellets or Corn/Pellet Mixture Only
37
Advertisement
Table of Contents
