4. Distribution Blower
Requires no lubrication.
Keep the motor windings and squirrel cage fan free of
dust. Can be wiped clean or vacuumed.
To remove distribution blower;
•
Slide the insert body out of the mounting frame.
•
Locate the blower in the back of the unit. You'll
need to tilt the unit forward for easy access.
•
Remove 8 tek screws using a 5/16" driver or
wrench.
8 screws
5. Feeder Body
Wipe or vacuum to clean.
Use a vacuum to remove fines and sawdust.
To access feeder cleanout;
•
Slide the insert body out of the mounting frame.
•
Locate the feeder cover from the right side of the
unit.
•
Loosen the wing nut approximately 3/4 of the way
out on the stud.
•
Pull out on the bottom of the cover then lift upward
to remove.
•
Notice the deflector shield is sitting loose in the
feeder. It can be removed by rolling it from under
the pusher arm shaft. Just be sure it is reposi-
tioned properly.
•
When re-installing cover, tighten the wing nut hand
tight only.
36
Pellets or Corn/Pellet Mixture Only
Loosen wing nut to remove cover
Vacuum fines from this area
3-90-775
P35i Fireplace Insert
Save These Instructions