Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Harman Stove Company INVINCIBLE PELLET INSERT
Summary of Contents for Harman Stove Company INVINCIBLE PELLET INSERT
- Page 1 INVINCIBLE PELLET INSERT OWNERS MANUAL...
- Page 2 Contents Packing List Installation & Assembly Operation ESP Control Maintenance Trouble Shooting Wiring Diagram Feeder Parts Specifications Manufactured by Harman Stove Company 352 Mountain House Road Halifax Pa. 17032 (717) 362-9080...
-
Page 3: Packing List
Packing List Inside Stove: (2) Firebricks Hardware Pack (1) Scraper (2) Electrical Terminals (1) Flame Guide (1) 10-32 x 1/2" Bolt (1) Cleaning Brush (1) 1/4 x 20 x 2 1/2" Bolt (2) 1/2 x 12" Threaded Rods (1) Wooden Handle (1) Brass Knob Inside Wing box (1) Control Board Wired to Stove... - Page 4 The Invincible Insert is made up of three main parts. They are the mounting shell, the wings, and the stove insert, fig. 1. A unique feature of this unit is the fact that the insert can be removed from the fireplace for service without removing the mounting shell, the Mounting Shell wings or disconnecting the flue pipe.
- Page 5 mounting. Be sure to put the green wires on the stud behind the wing. This stud also has the green Installing Insert wire from the power cord on it, fig 5. Slide two four foot long wood 2 x 4's into the Next slide the insert to within an inch of bottom of the shell as shown in fig.
- Page 6 Final Assembly Install Wooden Door Handle with 1/4 x 20 x 2 1/2 bolt. Install Brass Hopper Knob with 10-32 x 1/2 bolt. Install the two Firebricks on the angle iron behind the burn pot as shown in fig. 7. Remove tape from Flame Guide and make sure it is resting on the burn pot as shown in fig.
- Page 7 Operation Starting First Fire Be sure the power cord is plugged into a 120 volt receptacle. This can be verified by the red power light on the control panel. Fill the hopper with pellets, fig. 12. Fill the burn pot with pellets to a level just short Fig.
- Page 8 Starting a fire after proper Scrape floor of burn pot with scraper to remove any carbon build-up before Feed Rate is known. starting a new fire. Clean burn pot with scraper (supplied). Fill the hopper with pellets. Fill the burn pot with pellets to a level just short of overflowing.
- Page 9 When to use "Stove Temp Fig. 13 Mode" In "Stove Temp Mode" the Stove Temp Dial determines the temperature of the stove. Heat output and fuel consumption will remain con- stant. This makes it possible to tell how long a hopper full of pellets will last.
-
Page 10: Esp Control
1 to 7. Status light error messages: automatically reset. If the error continues call your Harman Dealer. 1 Blink: Indicates control board self diagnostic 3 Blinks: Indicates ESP (Exhaust Sensing Probe) failure. This requires a manual reset*.