Table of Contents
Advertisement
d. Un-latch and remove the ash pan. Dispose of the
ashes in a metal container with a tight fitting lid.
e. Remove the two (2) corner cleanout covers by re-
moving the wing-screws (one per).
f. Brush or vacuum the remaining ash from the fire-
box.
g. Guide the vacuum hose upward into the exhaust
passage in the right rear corner of the firebox.
Vacuum or brush exhaust passage
h. You can now return all pieces inside the firebox and
close the door.
i. Release the spring latches and slide the insert body
out onto the hearth or onto the service rail kit, if pur-
chased.
j. Remove the exhaust chamber access cover on the
right rear of the insert.
32
Pellets or Corn/Pellet Mixture Only
k. With this cover removed, you can vacuum the
paddle fan and the inside of the chamber. Be careful
not to bend the blades on the paddle fan.
l. Before reinstalling the access cover, make sure the
insulation between the two layers is in tact.
6. Inspect / Clean Hopper
•
Frequency: Whenever run to empty
•
By: User
Whenever the hopper is empty, inspect and remove
any large amounts of sawdust or fines. Although this
finer material will mostly feed through with the fuel,
large quantities of sawdust may restrict feeder flow.
3-90-775
P35i Fireplace Insert
Save These Instructions
Advertisement
Table of Contents
