Advertisement
Installation & Operating Manual
The Harman Exception Wood Fireplace Insert
"Ce manuel est disponible en Français sur demande"
R8
SAFETY NOTICE
PLEASE READ THIS ENTIRE MANUAL BEFORE YOU INSTALL AND USE YOUR NEW ROOM HEATER. FAILURE TO
FOLLOW INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE, BODILY INJURY, OR EVEN DEATH.
FOR USE IN THE U.S. AND CANADA. SUITABLE FOR INSTALLATION IN MOBILE HOMES
IF THIS HARMAN STOVE IS NOT PROPERLY INSTALLED, A HOUSE FIRE MA Y RESULT. FOR YOUR SAFETY, FOLLOW
INSTALLATION DIRECTIONS.
CONTACT LOCAL BUILDING OR FIRE OFFICIALS ABOUT RESTRICTIONS AND INSTALLATION INSPECTION
REQUIREMENTS IN YOUR AREA.
CONTACT YOUR LOCAL AUTHORITY (SUCH AS MUNICIPAL BUILDING DEPARTMENT, FIRE DEPARTMENT, FIRE
PREVENTION BUREAU, ETC.) TO DETERMINE THE NEED FOR A PERMIT.
CETTE GUIDE D'UTILISATION EST DISPONIBLE EN FRANCAIS. CHEZ VOTRE CONCESSIONNAIRE DE HARMAN ST OVE
COMPANY.
R1
R7
SAVE THESE INSTRUCTIONS.
Advertisement
Table of Contents
Related Manuals for Harman Stove Company R7R1 Exception Wood Fireplace
Summary of Contents for Harman Stove Company R7R1 Exception Wood Fireplace
-
Page 1: Safety Notice
Installation & Operating Manual The Harman Exception Wood Fireplace Insert “Ce manuel est disponible en Français sur demande” SAFETY NOTICE PLEASE READ THIS ENTIRE MANUAL BEFORE YOU INSTALL AND USE YOUR NEW ROOM HEATER. FAILURE TO FOLLOW INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE, BODILY INJURY, OR EVEN DEATH. FOR USE IN THE U.S. -
Page 2: Table Of Contents
Please read this entire manual before you install and use your new wood burning insert. Failure to follow instructions may result in property damage, bodily injury, or even death. SAVE THESE INSTRUCTIONS Harman Stove Company 352 Mountain House Road Halifax, PA 17032 Exception F200 Wood Insert... -
Page 3: Specifications
Specifications - Harman Exception, Model F200 Weight 425 lbs Flue Size 6 inch Log Length Recommended 18" with 20" Max Heating Capacity 1500 to 2000 sq. ft. Average Emissions 4.4 Grams Per Hr. Emissions on Low 2.25 Grams Per Hr. Blower Size 100 cfm variable speed The Harman F200 meets the U.S. -
Page 4: Operation
General Considerations Draft Before you install and operate your Exception wood insert, please read the entire contents of this manual. Pay particular attention to the explanation of draft and its ef fect in sert p er fo rman ce the Installation section. By following the installation and operating guidelines, you will ensure proper draft and gain maximum efficiency and enjoyment from your insert. - Page 5 Cette guide d'utilisation est disponible en francais Chez votre concessionnaire de Harman Stove Company SAFETY NOTICE: IF THIS HARMAN EX- CEPTION MODEL F200 INSERT IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESULT. FOR YOUR SAFETY, FOLLOW INSTALLATION DIRECTIONS. CONTACT LOCAL BUILDING OR FIRE OFFICIALS ABOUT RESTRICTIONS AND INSTALLA- TION INSPECTION REQUIREMENTS IN...
-
Page 6: Building A Fire
Controls Two important controls - the damper handle and the air control lever regulate the operation and output of the insert. Move the handle to the forward position (ap- proximately 3") and the handle automatically opens the bypass damper. In this mode of operation the combus- tion gases go directly from the main combustion chamber to the flue collar and exit into the chimney. - Page 7 When the air setting is low, the blower should always be at the minimum setting (corresponding to a blower speed of 750 RPM.) At higher settings above first notch the blower may be set to your desired comfort level. Be sure that the blower cord does not run under, over, above or in front of the insert.
-
Page 8: Maintenance
Like all fine equipment, your Exception requires some routine maintenance and inspection. Follow the guidelines in this section to guarantee safe, efficient operation. The Insert Surface The insert’s exterior surface should be dusted periodically with a soft cloth. For more thorough clean- ing, wait until the insert is cool before using a damp cloth to clean any blemishes. - Page 9 Gaskets Gaskets are used at strategic positions when build- ing the Harman Exception for controlling the path that incoming and outgoing air and gases take through the in- sert. You must check these gaskets from time to time, and replace them when necessary. The gaskets are made of fiberglass of different sizes (obtainable from Harman Stove Company) and are fixed in place with a high tem- perature gasket cement.
-
Page 10: Installation
Assembly Parts To Be Assembled Damper Control Left Wing Air Adjuster Rod Left Corner Trim Assembling The Wings Top Wing Bolts Damper Rod Side Wing Bolts Using a allen wrench, install left and right side wings with -20 button head bolts. Next install top wing use the same size bolts. - Page 11 Warning: Do not install in sleeping room. 8" 16"USA 18"Canada Floor Protector Mantel Notch The blower cord can be routed to either side after removing the ash lip and base cover. Route the cord to right or left by placing the cord in the proper notch shown above.
- Page 12 For direct connect and positive connect installations, ensure that the liner is securely connected to the insert flue collar. Tile Liner Steel Plate Chimney Cap Sealing Plate Exception F200 Wood Insert Masonry Direct Connect Installation This method is most commonly used because it is less expensive than the other methods.
- Page 13 Chimney Cap Sealing Plate Chimney Liner Exception F200 Wood Insert Zero Clearance Fireplace Requirements These are factory bulit insulated metal fireplaces that are usually framed into the wall with lumber. The term, "Zero Clearance" refers to the fact that wood fram- ing material can be in contact with the outer shell of the unit.
-
Page 14: Parts Diagram
Exception F200 Parts BODY WELDMENT 1-89-09102 DAMPER ARM COVER 2-00-34133 DAMPER LINK 2-00-34120 WOODEN KNOB 3-40-05662 LEFT SIDE COVER 2-00-34127 AIRSLIDE 2-00-34113 HCS 1/4-20 X 7/8 3-30-1252008713 3/8OD X 1/2” BUSHING 3-50-05229 AIR ADJUSTER 1-10-34112 5/16” COIL SPRING 3-40-00088 AFTERBURNER 3-40-05171 DAMPER AND FRAME 1-10-08060... - Page 15 Appendix A Determining Thickness Requirements of Alternate Hearth Extension Materials. If a manufacturer’s specifications call for a material having a minimum thickness of one inch with a certain k value, any material substituted for that specified material must have the same thickness and have the same or lower k value, or if the k value of the selected alternate material is higher, a greater thickness of that material must be used.
-
Page 16: Warranty
Harman Stove Company. This warranty does not apply if the product has been altered in any way after leaving the factory. Harman Stove Company and its agents assume no liability for “resultant damages of any kind”...