Setting The Vehicle Dynamics Display - Pioneer AVIC-X1 Operation Manual

If installed correctly, "OK" appears. Indicates
whether the Installation position of the naviga-
tion unit is correct or not. When the naviga-
tion unit is installed with an extreme angle
exceeding the limitation of the installing
angle, "Incorrect angle" will be displayed.
When the angle of the navigation unit has
been changed, "Excessive vibration" will be
displayed.
(4) Hand brake
When the handbrake is applied, "On" is dis-
played. When the handbrake is released,
"Off" is displayed.
(5) Power Voltage
The power supply (reference value) provided
from the vehicle battery to this unit is shown.
If the voltage does not fall within the range of
11 to 15V, check that power cable connection
is correct.
(6) Illumination
When the headlights or small lamps of a vehi-
cle are on, "On" is displayed. (If the orange/
white lead is not connected, "Off" appears.)
(7) Back Signal
When the gear lever is shifted to "R", the sig-
nal switches to "High" or "Low". (Which of
these is displayed depends on the vehicle.)
Setting the Vehicle Dynamics
Display
You can change the values displayed by the
instruments on the left and right of the Vehicle
Dynamics Display.
Until the sensor's initial learning is complete,
only the voltage and clock are displayed.
1
Switch to the Vehicle Dynamics Display.
➲ Changing the map display mode ➞
Page 22
2
Touch the left or right instrument.
Touch keys are displayed.
3
Touch the items you want to display.
52
You can select the following items.
• Voltage
Displays the power supply and voltage sup-
plied from the battery to this system.
• Acceleration:
Acceleration in a forward direction is dis-
played. The + sign indicates acceleration
while the – sign indicates deceleration.
• Side Acceleration:
Acceleration in a side direction such as when
turning, is displayed. The + sign indicates a
right turn, while the - sign indicates a left turn.
• Angular Velocity
Displays the vehicle's turning angle over one
second (how far it has turned in a second).
• Slope
Displays the vehicle's vertical movement. The
+ side represents the rising angle, and the -
side the falling angle.
• Direction:
The direction your vehicle is travelling in is
displayed.
• Clock :
Current time is displayed.
• Adjust Look:
Touch "Adjust Look" to display a screen for
selecting the panel pattern. Touch one of the
patterns from among those displayed
onscreen to change the panel to the selected
pattern.
❒ If you touch "Peak Hold Reset", the maxi-
mum and minimum (green line) values
indicated in "Acceleration" and "Side
Acceleration" are reset.
❒ You cannot change the speedometer at the
centre.
❒ Selecting Demo mode in the Settings
menu enables you to perform a demon-
stration with random values.