Setting The Bass Control - Alpine CVA-1014R Owner's Manual

g g g f f f
bass g g f f
engine
bass engine
g g g g g f f f f f

Setting the Bass Control

You can change the Bass Frequency emphasis to
create your own tonal preference.
1
When the monitor is open, press bass engine.
BASS ENGINE mode is displayed in the monitor.
2
Press preset 1 to select the desired mode.
3
Press the g or f to adjust the selected
mode.
Bass Level : -7~+7
You can emphasize or weaken the bass
frequency.
Bass centre frequency :
→
60Hz ↔ 70Hz ↔ 80Hz ↔ 90Hz ↔ 100Hz ↔ 130Hz ↔ 150Hz ↔ 200Hz
Emphasizes the displayed Bass frequency
ranges.
Bass Band Width (Q-Factor):
→
WIDE1 ↔ WIDE2 ↔ WIDE3 ↔ WIDE4
(Narrow) ← .............................. → (Wide)
Changes the displayed frequency's band width
to wide or narrow.
Preset 1
preset 1
←
←
Other Useful Features
4
Press bass engine to return to the normal
mode.
NOTES
• If no buttons are pressed within 10 seconds, the Bass
control setting will be turned off automatically.
• Depending on the type of external audio processors
connected to the unit, you may not be able to set some
settings.
• The settings of the Bass will be individually
memorized for each source (FM, MW, LW and CD)
until the setting is changed. Depending on the
connected devices, some functions and display
indications do not work.
Operation with the monitor closed
You can set the Bass control with the monitor
closed.
1
Press the bass engine.
2
Press preset 1. BASS is displayed for 2
seconds in the sub-display, then the value of
BASS Level blinks.
3
Each time you press preset 1, the blinking
shifts.
Example of sub-display
4
Press the g or f to adjust the selected
mode.
37
-EN