Navigation System Operation (Optional); Turning On The Navigation Mode; Interrupt Feature (Nav. Mix); Interrupt Feature (Nav.mix Out) - Alpine CVA-1014R Owner's Manual

Navigation System Operation (Optional)

SOURCE/
POWER MUTE/SETUP
g f

Turning on the Navigation Mode

If an optional Alpine Navigation System is
connected, the display shows the navigation
screen.
1
Press SOURCE/POWER to select the
Navigation mode.
NOTE
If the Navigation mode does not appear in the display by
pressing SOURCE/POWER, set the external setting of
NAV.IN to ON (Refer to "Setting the External Input" on
page 45).

Interrupt Feature (NAV. MIX)

With an Alpine navigation system connected to
the CVA-1014R/CVA-1014RB/CVA-1014RR, the
voice guidance of the navigation system will be
mixed with the radio or CD audio, etc. You can
also adjust the volume level of the voice guidance.
If you use this unit connected to an external audio
processor, you cannot use this function (except
PXA-H700/PXA-H701 series).
1
When the monitor is open, press and hold
MUTE/SETUP for at least 2 seconds. The
SETUP screen appears.
2
Press preset 5 to activate the SYSTEM setting
mode. Press preset 5 again to select NAV. MIX.
28
-EN
3
4
Preset 5

Interrupt Feature (NAV.MIX OUT)

With an Alpine navigation system connected to
the CVA-1014R/CVA-1014RB/CVA-1014RR, the
navigation system's voice guidance is mixed in
and output from the Rear/Subwoofer Output RCA
connectors.
This function is not available when an external
audio processor is connected.
1
2
3
4
Press g or f to select ON or OFF.
ON: The volume level of the navigation system's
voice guidance can be adjusted in 15 steps.
OFF:The navigation system's voice guidance is
not output.
(For details about adjusting volume level, refer to
"Adjusting Volume/Balance/Fader" on page 8.)
For any other settings, press preset 5 or another
preset button.
After setting is completed, press MUTE/SETUP
to return to normal mode.
NOTES
• The volume level of the audio will be automatically
reduced when the voice guidance of the Navigation
system starts.
• When the voice guidance of the Navigation system
starts to interrupt the audio, the display is
automatically changed to the navigation screen.
When the monitor is open, press and hold
MUTE/SETUP for at least 2 seconds. The
SETUP screen appears.
Press preset 5 to activate the SYSTEM setting
mode. Press preset 5 again to select NAV.MIX
OUT.
Press g or f to select ON or OFF.
Select ON to allow the navigation system's voice
guidance to interrupt the external amplifier.
For any other settings, press preset 5 or another
preset button.
After setting is completed, press MUTE/SETUP
to return to normal mode.