Installation And Connections - Alpine CVA-1014R Owner's Manual

Installation and Connections

To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries
various noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
Parking Brake Lead Connection
If necessary, use a pinch connector to connect the parking brake lead, etc.
1
Vehicle Cable
Connection Diagram of SPST Switch (Sold Separately)
(If the ACC power supply is not available)
CVA-1014R/
CVA-1014RB/
CVA-1014RR
NOTES
• If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold
separately).
• The diagram and the fuse amperage shown above are in the case when CVA-1014R/CVA-1014RB/CVA-1014RR is used individually.
• If the switched power (ignition) lead of the CVA-1014R/CVA-1014RB/CVA-1014RR is connected directly to the positive (+) post of the
vehicle's battery, the CVA-1014R/CVA-1014RB/CVA-1014RR draws some current (several hundred milliamperes) even when its switch is
placed in the OFF position and the battery may be discharged.
56
-EN
Pinch Connector
Monitor Cable
Stopper
ACC
(Red)
BATTERY
(Yellow)
2
SPST SW (Optional)
Pliers
FUSE (5A)
(Optional)
FUSE (10A)
(Optional)
Battery