Automatic Memory Of Station Presets; Tuning To Preset Stations; Selecting A Station From The List - Alpine CVA-1014R Owner's Manual

Radio Operation
SOURCE/
POWER BAND/TEL.
g g g g g f f f f f
(Rotary
encoder)
Automatic Memory of Station
Presets
1
Press SOURCE/POWER to select the radio
mode.
2
Press BAND/TEL. repeatedly until the desired
radio band is displayed.
3
Press and hold TUNE/A.ME for at least 2
seconds.
The frequency on the display continues to
change while the automatic memory is in
progress. The tuner will automatically seek and
store 6 strong stations in the selected band. They
will be stored into presets 1 to 6 buttons in order
of signal strength.
When the automatic memory has been
completed, the tuner goes to the station stored in
the preset location No. 1.
NOTE
If no stations are stored, the tuner will return to the
original station you were listening to before the auto
memory procedure began.
10
-EN
TUNE/A.ME
Station preset
MODE
buttons (1 through 6)

Tuning to Preset Stations

1
Press SOURCE/POWER to select the radio
mode.
2
Press BAND/TEL. repeatedly until the desired
radio band is displayed.
3
Press the station preset button that has your
desired radio station in memory.
The display shows the band, preset No. and
frequency of the station selected.

Selecting a Station from the List

You can display the list of your titled stations (refer
to "Titling Discs/Stations" on page 36), and select
a station from this list.
1
When the monitor is open, press and hold the
MODE (Rotary encoder) for at least 2 seconds.
The title list is displayed.
2
Press g or f to select a station from the
list.
3
Press the MODE (Rotary encoder) to tune in
the selected station.
NOTE
To cancel the title list display, press and hold the
MODE (Rotary encoder) for at least 2 seconds.