Recalling Preset Rds Stations - Alpine F1 Status CDA-7990R Owner's Manual

RDS Operation
SETUP
DN
UP
TUNE

Recalling Preset RDS Stations

1
Press the FUNC button to light the function
indicator in red and set the Function mode to ON.
2
Press the AF button to activate the RDS mode.
The display shows "AF" when the RDS mode is
activated.
3
Press the 1 through 6 buttons in which your
desired RDS station is preset. If the preset
station's signal is weak, the unit automatically
searches and tunes to a stronger station in the
AF (Alternative Frequencies) list.
4
If the preset station and the stations in the AF list
cannot be received:
The unit searches again for a station in the PI
(Programme Identification) list.
If there are still no stations receivable in the area,
the unit displays the frequency of the preset
station and the preset indicator disappears.
If the signal level of the Regional (Local) station
being tuned becomes too weak to receive, press
the same preset location button to tune in a
Regional station in other district.
5
To set the Function mode to OFF, press the
FUNC button again.
28
-
EN
AF
Preset buttons
1~6
FUNC
Function indicator
• For presetting the RDS stations,
refer to the Radio Operation
section. The RDS stations can be
preset in the FM1, FM2 and FM3
bands only.