Speedtouch™ Usb Connection Setup For Microsoft Windows Operating Systems - THOMSON SpeedTouch 510 Setup And User Manual

1.2.2 SpeedTouch™ USB Connection Setup for
Supported Operating
Systems
Minimum system
requirements
Prerequisites
Installing the
SpeedTouch™ USB
connection
E-SIT-CTC-20030306-0003 v3.0
Microsoft Windows Operating Systems
Installing and using the SpeedTouch™ USB connection is supported for following Micro-
soft Windows Operating Systems:
•
Windows 98/98SE or Windows ME
•
Windows 2000 or Windows XP
You may need the Windows installation CD-ROM during installation.
• For Windows 98/98SE/ME:
•
Pentium processor 166 MHz or compatible
• 32 megabytes (MB) of memory
•
For Windows 2000/XP:
• Pentium II processor or compatible
•
64 MB of memory
• 30 MB of free disk space
Make sure to remove any previous SpeedTouch™USB or SpeedTouch™330 installation
that may reside on your PC before you install the USB drivers from the Speed-
Touch™Setup CD-ROM.
The installation is Plug and Play, meaning that installation will require almost no effort.
Make sure both your PC and SpeedTouch™ are turned on and operational.
Proceed as follows
Insert the USB cable provided into the SpeedTouch™ USB port marked with the
1
USB logo: .
The other end of the USB cable fits in (one of) the USB port(s) of your PC. In
2
most cases your PC's USB port is marked with the same USB symbol.
You can also connect your computer to the SpeedTouch™ via a USB
Note
hub.
Windows will automatically recognize the SpeedTouch™:
3
The Windows Found New Hardware Wizard appears:
4
This wizard will guide you through the installation procedure of the Speed-
Touch™USB drivers.
Click to continue.
Next
1 SpeedTouch™ Installation
13