THOMSON SpeedTouch 510 Setup And User Manual page 19

Installing the
SpeedTouch™ USB
connection on a
Mac OS 10.x platform
E-SIT-CTC-20030306-0003 v3.0
The following screen appears:
5
Click to continue.
OK
At the end of the procedure, the following window appears:
6
Click to finish the installation and restart your computer.
Restart
After restarting your computer, the SpeedTouch™ USB drivers are fully installed
7
and ready for use.
Insert the USB cable provided into the SpeedTouch™ USB port marked with the
USB logo: .
The other end of the USB cable fits in (one of) the USB port(s) of your computer.
In most cases your computer's USB port is marked with the same USB symbol.
Optionally you can connect another computer, using its Ethernet port, before
continuing with the SpeedTouch™ Configuration Setup described in
"1.3 SpeedTouch™ Configuration Setup" on page
Make sure both your computer and SpeedTouch™ are turned on and operational.
Proceed as follows:
Insert the USB cable provided into the SpeedTouch™ USB port marked with the
1
USB logo: .
The other end of the USB cable fits in (one of) the USB port(s) of your computer.
2
In most cases your computer's USB port is marked with the same USB symbol.
Insert the SpeedTouch™ Setup CD-ROM.
3
Open the OSX folder and double-click
4
procedure.
You need administration rights to perform this installation. If the installation
Note
wizard prompts you for authorization, click
name and password or phrase.
1 SpeedTouch™ Installation
20.
to start the installation
SpeedTouchUSB
to enter the administrator
17