THOMSON SpeedTouch 510 Setup And User Manual page 25

E-SIT-CTC-20030306-0003 v3.0
The Setup wizard will continue to search for the SpeedTouch™ on the network.
7
The following window shows the detection progress:
The Setup wizard should find your SpeedTouch™ device on the local network.
8
This is indicated by the following window:
In case more than one SpeedTouch™ device is found, a listing is provided from
which you can select your SpeedTouch™.
If the Setup wizard does not find any SpeedTouch™ on the network an
Note
error window pops up. In this case check:
•
Whether the SpeedTouch™ is turned on and fully initialized.
•
Whether your PC is correctly connected to the SpeedTouch™
(Ethernet or USB).
• Whether no dedicated firewall device or router is placed
between your PC and the SpeedTouch™ and whether no
personal firewall software is running on your PC (in case of
Ethernet connectivity).
• Whether the SpeedTouch™ USB drivers are correctly and fully
installed (in case of USB connectivity).
To repeat the search for the SpeedTouch™, click
this procedure.
To continue with the configuration of your SpeedTouch™ and your PC, proceed
9
with the configuration procedure described below.
1 SpeedTouch™ Installation
and proceed with step
Back
7 of
23