Table of Contents
Advertisement
4 SpeedTouch™ System Software Upgrade
66
If the Setup wizard does not find any SpeedTouch™ on the network an
Note
error window pops up. In this case check:
•
Whether the SpeedTouch™ is turned on and fully initialized.
•
Whether your computer is correctly connected to the Speed-
Touch™.
•
Whether no dedicated firewall device or router is placed
between your PC and the SpeedTouch™ and whether no
personal firewall software is running on your PC (in case of
Ethernet connectivity).
•
Whether the SpeedTouch™ USB drivers are correctly and fully
installed (in case of USB connectivity).
To repeat the search for the SpeedTouch™, click
procedure.
Once the SpeedTouch™ Setup wizard has detected your SpeedTouch™ device
6
you can proceed with the upgrade procedure.
If more than one SpeedTouch™ device is listed, select the appropriate one.
Then, click
to proceed.
Next
The following window shows current the firmware version active on the Speed-
7
Touch™ as well as one or more firmware versions available on the CD-ROM.
Select the appropriate firmware version and click
If the Service Provider has included a separate disk with dedicated upgrade
Note
system software, click Have Disk to navigate to the location of the appro-
priate file.
In case of a system software downgrade you must specifically acknowledge your
8
decision before being able to proceed.
The following window allows you to overview your selection:
9
Click
to continue.
Next
and proceed with step
Back
to continue.
Next
E-SIT-CTC-20030306-0003 v3.0
4
of this
Hide quick links:
Advertisement
Table of Contents
