THOMSON SpeedTouch 545 Setup And User Manual page 62

5 SpeedTouch™ Web Interface
60
•
Define a default server:
By specifying a default server IP address (e.g. 10.0.0.154 as shown above), all
incoming connections that don't match a specifically configured static NAPT entry
will be forwarded to the device with this IP address. This setting should be
adequate for most server applications and eliminates the need for specific static
NAPT entries.
•
Configure UPnP™:
The three UPnP™ configurations are:
•
Full:
The SpeedTouch™ is UPnP™ enabled, all local hosts are able to detect the
SpeedTouch™. Any local host is able to create port mappings for any local
device.
•
Secure:
The SpeedTouch™ is UPnP™ enabled, all local hosts are able to detect the
SpeedTouch™. A local host is allowed to make port mappings for its own,
i.e. a local host is not allowed to create port mappings for other local
devices.
•
Off:
The SpeedTouch™ is UPnP™ disabled, none of the local hosts is able to
detect the SpeedTouch™. Via UPnP™ no port mappings can be created.
E-DOC-CTC-20030814-0001 v1.0